Jump to content

Billet Thermostat Housing - Group Buy


HI PSI

Recommended Posts

  • Member
  • Member For: 17y 10m 3d
  • Gender: Male
  • Location: Central Queensland
On 11/05/2019 at 8:48 PM, arronm said:

My Fenix is Adrad.   PWR is better quality.

Does the thickness of the radiator reduce clearance between the fans and the front of the engine? Or does it transfer towards the front of the car? Only asking, as I have limited room even with the standard radiator..

Link to comment
Share on other sites

  • XR50T
  • Gold Donating Members
  • Member For: 10y 10m 27d
  • Gender: Male
  • Location: Western Sydney

Not adrad but when I had an alloy fenix fg prototype radiator the end tanks where set the same as factory and just the core was thicker.

It's the same with their 32mm that has plastic tanks.
Should also not my mates BF PWR rad is the same.

So end tanks stay as factory but the core sits in and out further.

Link to comment
Share on other sites

  • Dropping a turd
  • Gold Donating Members
  • Member For: 16y 5m 1d
  • Gender: Male
  • Location: Perth
2 hours ago, HI PSI said:

Does the thickness of the radiator reduce clearance between the fans and the front of the engine? Or does it transfer towards the front of the car? Only asking, as I have limited room even with the standard radiator..

 

Clearance to condenser and intercooler stays the same. All the width is towards the motor. So yes fans get close to engine. My rad is 50mm . This is my clearance.

 

OLIIHPVh.jpg

 

hFP3eCRh.jpg

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'