Jump to content

BF TURBO MANUAL TEMP NOT RIGHT


BFTURBO_MKII

Recommended Posts

  • New Member
  • Member For: 5y 11m 15d

Hi all dont crucify me if its already been asked but im having issues and im stumped as to why . 2007 xr6 turbo manual bf ive recently changed water pump , done new hoses ,changed temp sensor ,thermostat and changed and flushed cooolant 2 times now . And today I even went out of my way to let the car run with the filler bottle cap off and long story short the car runs considered normal temps when the cap is off (just above quarter) and every so often spikes up and does the usual thermo fans kick in cools it down then back to normal thermo fans shut off . But when the filler cap is then placed back on the filler bottle temps spike after maybe 2-3 mins thermo fans kick in and its an endless battle to run car colder and the thermo fans never turn off as its running "hot" never gets to half way but its not normal for this car . I have no clue as to why and how its doing it any advice/help greatly appreciated.

Edited by BFTURBO_MKII
Link to comment
Share on other sites

  • Puff
  • Gold Donating Members
  • Member For: 9y 2m 21d
  • Gender: Male
  • Location: South Australia
19 minutes ago, BFTURBO_MKII said:

ive recently changed water pump , done new hoses ,changed temp sensor ,thermostat and changed and flushed cooolant 2 times

 

18 minutes ago, BFTURBO_MKII said:

never gets to half way but its not normal for this car

 

I'd say that all of those new parts have changed what you consider normal.

 

My car runs at about 1/3rd on the gauge mostly and gets near half on a summer day with the aircon running.

 

Just put the cap on and drive it. If it gets over half then get worried but until then I wouldn't consider it an issue.

Link to comment
Share on other sites

  • New Member
  • Member For: 5y 11m 15d

My main concern is the thermo fans are constantly on not so much where my temp gauge is sitting to be completely honest . As I stated it runs fine with no filler cap on car its when it goes on gets out of hand with thermo fans temp gauges from factory I never trust anyway .

 

On 5/5/2018 at 5:50 PM, arronm said:

Sounds like system is getting over pressurized..

So I assume a simple flush wont fix it then ??

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'