Jump to content


Paulie2256

Which Pen.is Better?

Recommended Posts


I call bs it appears to be the same ink, need before sample writing to confirm actual change.

Also I changed the air in my interior today was going to grab a pic but its hard to drive with the windows down and get pic at the same time.

Share this post


Link to post
Share on other sites

I changed the ink in my pen today....

VbalHWv.jpg

rgicWSB.jpg

dXdLOng.jpg

Should have started a thread for this. With prices and install instructions.

Also how many words had the old ink written and what ViC word per minute rate?

Share this post


Link to post
Share on other sites

Should have started a thread for this. With prices and install instructions.

Also how many words had the old ink written and what ViC word per minute rate?

SA per minute rate is better for advertising as larger number of words.......

Coz our paper over here is reads higher

Share this post


Link to post
Share on other sites

Looks like new ink is already failing to meet the 23

When you do the oil change of a car you need a couple of cranks for the new oil to go through the engine. This happens with pens too. Maybe henz was right.

After a retune.

4KTH9gh.jpg

Edited by Paulie2256

Share this post


Link to post
Share on other sites

did you torque the end cap to spec? what is the spec? Home many run in letters/digits are required before you can go for full WPM?

Also, I have a black pen now but I want a blue one? can I fit a blue ink to my black pen? Also does anybody know if I can fit a black ink to my HB pencil? because I don't have my pen license but want to use a pen?

Share this post


Link to post
Share on other sites

Sorry guys its my first write up so didn't get into enough detail I guess, but these questions will benefit everyone in the future.

The torque spec is 2.5nm but I find that going to 2.5nm, then loosening it and then going again to 3nm will improve the ink flow and provide a better WPM.

3 zigs and 3 zags are required before you can hit full WPM. I measured the ball at 3000rpm and had flow of .34ml per min

Share this post


Link to post
Share on other sites

did you torque the end cap to spec? what is the spec? Home many run in letters/digits are required before you can go for full WPM?

Also, I have a black pen now but I want a blue one? can I fit a blue ink to my black pen? Also does anybody know if I can fit a black ink to my HB pencil? because I don't have my pen license but want to use a pen?

I see ten threads in there that should all be started individually and atleast a new one once a week on the same subject.

Share this post


Link to post
Share on other sites

I changed the ink in my pen today....

VbalHWv.jpg

rgicWSB.jpg

dXdLOng.jpg

Should have started a thread for this. With prices and install instructions.

Also how many words had the old ink written and what ViC word per minute rate?

Share this post


Link to post
Share on other sites

Can't edit my double post out.

Paulie were any late night classes required?

Share this post


Link to post
Share on other sites

C'mon pazz.

Won't see Paulie running no generic tune. Not with upgraded ink.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Donation Box

    Please donate to support the community.
    We appreciate all donations!


FordXR6Turbo.com Powered by Invision Community

×