Jump to content

Where To Get Xr6 Turbo To Manifold Bolts


usernumber1234

Recommended Posts

  • 3 weeks later...
  • Member
  • Member For: 11y 8m 5d
  • Gender: Male
  • Location: Maryborough Qld

just wondering if the bolts that hold the dump pipe to the cat converter pipe on a ba xr6t are loose to the point the bolts are hangin out/missing (3 of them)

can this cause problems??

I tightened up one and put another back in as it fell out also unsure about the third if it even exists still

can it cause problems?

I have not driven the car since tightening them as its still up on car stands atm as doing work on teh rear end lol

Edited by jas98
Link to comment
Share on other sites

  • Member
  • Member For: 11y 8m 5d
  • Gender: Male
  • Location: Maryborough Qld

I mean the turbo to dump pipe, sorry

but anyway f*ck me it boosts and pulls heaps better now, didnt think that would cause it?? I need to do up the one that I cannot get to but when I remove the turbo etc to change the engin mount, ill do it then

Link to comment
Share on other sites

  • 1 year later...
  • Member
  • Member For: 10y 1m 12d
  • Gender: Male
  • Location: Cairns

I tried everywhere in Cairns. Boltmasters, NQ Fasteners, muffler centres, Bursons, Repco, Autobarn, engine rebuilders etc. The only place that had the same studs (offset thread) was Ford.... $10 bucks each.

Link to comment
Share on other sites

  • 4 years later...
  • New Member
  • Member For: 5y 2m 5d

I was tightening my turbo to manifold bolts every couple of months. I end up getting Nord Lock washers (2 piece washer) off eBay, $20 for 4. 

 

I havent tightened them or smelt exhaust in they cabin for about 6 months so far. 

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'