Jump to content

P1227 Dtc (Wastegate Closed/boost Over Pressure) :( :( :(


gmhkla

Recommended Posts

  • Donating Members
  • Member For: 13y 10m 20d
  • Gender: Male
  • Location: Hoppers Crossing

thank you Mr_4.0 someone with a decent not so hard reply. it will be on the list of things to do in the coming days :D

Link to comment
Share on other sites

  • Member
  • Member For: 17y 10m 2d
  • Gender: Male
  • Location: @ my laptop

did you read post 2?

even if the wastegate is your issue, the SCT software can configure the tune so as not to set a fault

Edited by ratter
Link to comment
Share on other sites

  • I <3 Floods
  • Silver Donating Members
  • Member For: 12y 7m 28d
  • Gender: Male
  • Location: South West QLD
You have either 1 of 3 issues or possibly a couple combined

Your tuner does not know what to adjust

The HP does not allow correct turbo control

Your wastegate is not controlling the boost correctly, but either of the above can stop this from setting the code

I'll just quote it again incase..

Link to comment
Share on other sites

  • Donating Members
  • Member For: 13y 10m 20d
  • Gender: Male
  • Location: Hoppers Crossing

Ok then why only my car and not the other BAs BFs and FGs his done???????????????????????????????????????????

The wastegate could be internally faulty. Should you be able to move the rod and open the flap by hand?

Link to comment
Share on other sites

  • Member
  • Member For: 17y 10m 2d
  • Gender: Male
  • Location: @ my laptop

Many people can make power with these cars as that is the easy part, problem solving is an entirely different matter though.

SCT can stop this code from appearing for sure, I know this because I have seen cars with this issue, I would assume HP would also, but I do not use my HP for Ford as SCT has better control, I use my HP for holdens as it has better control on them compared to the SCT

Link to comment
Share on other sites

  • Donating Members
  • Member For: 13y 10m 20d
  • Gender: Male
  • Location: Hoppers Crossing

Hmmm, well I just gave the IAT and MAP sensors a clean. I'll get a wastegate actuator for it as I may need it for further future mods anyway and we will see how it goes.

One more question for you rattled. Should or shouldnt I be able to open the wastegate flap by moving the rod with my hand?

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'