Jump to content

Rear Control Arm Failure


XAH03

Recommended Posts

  • I see a red door and I want to paint it black
  • Donating Members
  • Member For: 14y 5m 3d
  • Gender: Male
  • Location: Far north queensland

Stock springs and yes the sway bar is 22mm, not sure if the bar had anything to do with it or there is not enough meat on the control arm at that point

same setup as mine

The later arms have a double skin on them, BF and FG I believe.

Neglecting the bushes can be a big issue for the arms too, when the original bushes get soft the link pin moves around and opens up the hole. This in turn allows up and down movement.

Mine is a 07/07 BF and I had the bushes replaced at around 40k, both control arm farked and replaced at 80k

Link to comment
Share on other sites

  • Moar Powar Babeh
  • Lifetime Members
  • Member For: 18y 6m 6d
  • Gender: Male
  • Location: Perth

Get a set of HD control arm links from P@ @ WHS. They remove the need for the bushes and also have a nifty stepped washer that effectivly doubles the load area on the control arm. In closing, they are most good.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'