Jump to content

Control Blade Bush


bjcrown

Recommended Posts

  • Donating Members
  • Member For: 18y 5m 10d

Guys,

I'm looking into replacing the Control Blade bushes with SuperPros (see pic). Have been advised that the old bushes are difficult to remove.

What is the best way to removed the old ones and replace them?

Any tips would be very much appreciated.

Thanks...

post-7548-0-47529300-1309048765_thumb.jp

Link to comment
Share on other sites

  • Member
  • Member For: 13y 11m 3d
  • Gender: Male
  • Location: Brisbane

I pressed mine out to fit nolathane ones in, had to cut the old ones out of the arm as a 20t press wsnt strong enough, then pressed the new ones in without to many problems, just have to watch te arm as you press it so it doesnt bend/flex much as there isnt alot of support to use while prssing

Sent from my OMNIA7 using Board Express

Link to comment
Share on other sites

  • 3 months later...
  • Member
  • Member For: 14y 10m 26d
  • Gender: Male
  • Location: Melb

Or should I just get them to use the super pro ones???

Also what's ppls opions on changing all three of the diff bushes to super pro comfort bushes?? Will this create more noise? Or should the smaller ones b replaced wth standard bushes? N center a super pro??

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'