Jump to content

Fg Catback Vs B Series Catback


STAINLESS again plz

Recommended Posts

  • Member
  • Member For: 15y 5m 25d
  • Gender: Male

Hey sorry just found this thread, Yeah the Fg cat-back does fit the b series I have the 4" xforce on my tornado fitted by Mick (Pit Lane) he said it was a bit of a *beep*!

Some cutting and welding was involved but that was because of the cat being welded in, this is were the adjustment was made. Downside is it sat really low, I mean 40mm off the ground!! Must say Mick wanted to get it sitting better but I needed the ute and it had also just made 380rwkw so I was a bit impatient.

Since then I have had it adjusted by an exhaust shop, they cut 20+mm out off the dump pipe to lift it up and lined up the pipe above diff so it wouldn't hit on big bumps.

While I was at it I had the tip that looked like a drain pipe sticking out the rear bar changed too a dump which is back in under the rear bar all painted black.

Edited by PSIFPV
Link to comment
Share on other sites

  • Replies 24
  • Created
  • Last Reply

Top Posters In This Topic

  • Three pedals are better then two..
  • Donating Members
  • Member For: 16y 10m 23d
  • Gender: Male
  • Location: Melbourne

Ok but does the ba,bf fit a fg?

If there's stuffing around to go the other way I'm sure there's stuffing around to go this way.

Link to comment
Share on other sites

  • 5 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.



×
  • Create New...
'