Jump to content

Adding Rca Pre-outs To Icc Guide Is Here


quadie

Recommended Posts

  • Donating Members
  • Member For: 18y 4m 24d
  • Gender: Male
  • Location: Muswellbrook,NSW

thanks for the prompt service!

Audio IC info:

Toshiba

TA8276HQ

5ugm77

M'aisa

DATASHEET\

and with this data , I have worked out a remote for amp control

so I will add this data as soon as I can test it out (im in the middle of doing it , but got to excited , so I posted it be4 im finished :P

Edited by Dagabond
Link to comment
Share on other sites

  • Member
  • Member For: 16y 1m 2d

So basically your saying the audio quality will be heaps better if I go RCA and not levels into my amp? and this is for the crappest bottom line ICC

I don't expect to understand why but if it actually has some benefit then I'll take the time to do this.

Link to comment
Share on other sites

  • Into the laaaake
  • Member
  • Member For: 16y 9m 14d
  • Gender: Male
  • Location: Nrth Qld
thanks for the prompt service!

Audio IC info:

Toshiba

TA8276HQ

5ugm77

M'aisa

DATASHEET\

and with this data , I have worked out a remote for amp control

so I will add this data as soon as I can test it out (im in the middle of doing it , but got to excited , so I posted it be4 im finished :P

IC details greatly appreciated mate!!!!!!!!!!!!!!

Link to comment
Share on other sites

  • Donating Members
  • Member For: 18y 4m 24d
  • Gender: Male
  • Location: Muswellbrook,NSW
So basically your saying the audio quality will be heaps better if I go RCA and not levels into my amp? and this is for the crappest bottom line ICC

I don't expect to understand why but if it actually has some benefit then I'll take the time to do this.

unless u have a lc6 or simiilar , the 10 bucks u spend on bits at DSE is well worth the effort

if u live newcastle or syd pm me and ill let u hear the difference!

Link to comment
Share on other sites

  • Member
  • Member For: 16y 1m 2d

Good guide, printed it out and did it last night.

-Took 6 hours

-Little screws were hard to get out, needed pliers on my screwdriver to break the seal

-Needed another pair of hands

-Needed a magnifying glass

-Need a really really fine soldering iron, really

Link to comment
Share on other sites

  • Into the laaaake
  • Member
  • Member For: 16y 9m 14d
  • Gender: Male
  • Location: Nrth Qld

Or pin 6 and 20 are Vcc. But im not sure if the IC runs on a 12v rail? If it is a 12v rail I would think that there would only be Vcc applied there when the ICC is turned on.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'