Jump to content

The Off Topic Thread.


KEN 24T

Recommended Posts

  • Gold Donating Members
  • Member For: 8y 11m 28d
  • Gender: Male
  • Location: Canberra ACT

Did the in tank filter last time - wasn't that bad. This time I'm pulling the tank out for a clean to hopefully stop the problem happening again, as the filters aren't cheap. Basically replace the whole module and swap the pump and reg onto the new one.

Link to comment
Share on other sites

  • Puff
  • Gold Donating Members
  • Member For: 9y 2m 21d
  • Gender: Male
  • Location: South Australia

The pcm was already licensed from another car, it shows it at the start of the clip.

 

Old mate has a 600rwkw falcon too, so the channel is worth a look!

  • Like 1
Link to comment
Share on other sites

  • Gold Donating Members
  • Member For: 8y 11m 28d
  • Gender: Male
  • Location: Canberra ACT

Haha never trust a workshop manual. Kluger manual reckoned the entire rear end had to come out to drop the fuel tank.

Looked unnecessary to me. Couldn't quite get the heat shield out or access the rear bolts on the tank straps. But made a nice slide for the tank

Tank out, cleaned and back in with new filter. Fuel trims back to normal.81b87ceba12fe2b6294ede1b8c3ba4b6.jpg

  • Like 2
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'