Jump to content

Piston Selection To Fit Argo Rods.


01txr

Recommended Posts

  • Member
  • Member For: 17y 2m 14d
  • Gender: Male
  • Location: QLD

I have a set of Argo rods and am wanting to know what people have used and what there feedback has been on the pistons of choice and also what rings I should use.

However I will not use acl piston's ever again after 3 different engines I know of have all broken the ring lands, and these engines where non blown.

keep in mind I will be looking at near to 450rwkw out of this with the lowest boost to achieve it.

Link to comment
Share on other sites

  • Member
  • Member For: 17y 2m 14d
  • Gender: Male
  • Location: QLD

What price are they and where do you suggest I purchase from?

You have used them on the Argo rods?

How are they for noise?

And what boost and power can they handle?

I will be also looking for a trustworthy good engine builder to build and fit it as I have not the time to do it at present.

Can you give me any name's for this that are located South QLD?

Link to comment
Share on other sites

  • Donating Members
  • Member For: 21y 3m 5d
  • Gender: Male
  • Location: Perth, WA

I have tried CP pistons, and heard a few cars with them, and if you like a mechanically quiet engine, well I wouldn't use them again :nono:

My latest engine build use Atomic 'Fat Rods' and Mahle pistons, and though not quite stock sounding, it is pretty close.

I have built a 2nd engine for R_UTE, also using Atomic rods and Mahle pistons, and the results are the same, pretty quiet.

Pistons are rated just over 100 kw per cylinder (650 kw total, which is 860 hp) so that will suffice for most.

Hope this helps :spoton:

Link to comment
Share on other sites

  • Member
  • Member For: 17y 2m 14d
  • Gender: Male
  • Location: QLD

Thanks ninka.

Don't want a rattly sounding engine.

Do the CP's only rattle when cold or all the time.

How much where the Mahle's and where do you suggest to purchase?

Are these the same brand as the oem gen3 pistons?

Just that when I worked at zupps these where the piston ordered for replacement in batch's every week.

May have been a better piston to replace the original crate engine's poorly machined versions.

Does Federal Mogal (TRW) do a piston to suit?

Link to comment
Share on other sites

  • Donating Members
  • Member For: 20y 5m 6d
  • Gender: Male
  • Location: Sydney NSW

I have had the CP pistons in now for over 4 months and there are no rattles at all. Car sounds stock at idle. Under acceleration, too hard to know over the induction noise ;)

Regards

M G

Edited by Master G
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'