Search the Community
Showing results for tags 'na turbo'.
For a BA N/a to Turbo conversion using all factory gear. Would getting the PCM flashed to the stock turbo tune via SCT/HPTuners/PCMtec with an independent boost controller (bleed valve), Turbo Logic turned off and a 2 bar MAP sensor have any issues? My understanding is that Turbo Logic is the factory boost control option using the boost pressure sensor in the piping and solenoid for the wastegate which requires extra wiring etc. that I don't have. Around how much would it cost to flash the PCM to the factory program? I know a full custom dyno tune is the best choice but don't have the coin yet and dont want to lean it out on an NA tune and map sensor
Hi everyone sorry for my shocking spelling but am typing this off my phone. Hi everyone I have a 2003 Ford ba Futara wagon and I am in the process of turboing it anyways iv been seeing a lot of people slapping turbos on the na fords and thought to myself what a good idea. soniv done some research on the topic and watched countless amounts of videos on it and also hearing a lot of success story’s on all the forums, so I decided to give it ago as I have mechanical knowledge I decided to give it my best shot. I acquired all if not more than enough parts to get this working. so a week ago I started to dismantle the engine and I removed the whole n/a parts and have replaced everything with turbo running gear from a donor car I have then installed turbo, dump pipe, fuel pressure reg, drivers side loom steering Colum, radio and blue box cars main computer in engine bay and attached the 3rd plug for the turbo computer, 2 bar maf sensor and have kept the n/a engine loom but have hard wired and matched the colours for the 2 bar maf sensor. I am using the factory crossover and Bov I have all turbo intercooler piping installed and sensors. im using factory coils and plugs. key and remote have been matched to the car and locks and unlocks. anyways I have tried to start my ba and it goes to fire but then stalls, it fires once then nothing it won’t stay idleing I have tried to diagnose what the hell is wrong with it but no luck. everything seems to be right? Iv tried to run the na computer and no maf at all but still nothing? local mechanic said if I have all the computers keys and parts from same car there shouldn’t be an issue with it... sorry guys dragging on a in a bit but trying to explain in as much detail as possible when I go to start the car it fires up but dies. do I need to get a sct flash tool? or anybody have had this problem before?