007BFXR6TURBO

After driving the car today and then driving the car hard on the acceleration of the line and while cruising the speedo has cut out and then I have pulled over and restarted the car, and it was all good. My next steps seem like I will need to change the rear wheel speed sensors, given that the left one is surprisingly worn out more than what I would have expected for a car that is 18 years old with 140,000km on the clock. Dad had a 2005 December build BF MKI XR6 Turbo and never did we have this issue and that car did 200,000km. Front Left Front Right Rear Left: Looks completely flat on the surface . Rear Right: Still has the inner circle that is a present, compared to the left one, which is completely flat.

Just an update on the situation. I have changed fuses, and that did not improve the situation. I've taken the community's advice and I cleaned all four wheel sensors. I'm not sure how to upload images however the front ones had swarf which I cleaned with brake cleaner and that looked fine. I then did the rears and the left rear one looks worn out as I suspected as any time when I would apply accleration I would feel that the rear left was the wheel which was always lagging behind when applying the power down. On the right rear, it had what appears to be normal wear. My next steps will be to replace both rear wheel speed sensors if the problem comes back as I am yet to properly drive the car to the point where I can test the speedo to cut out under overtaking or hard acceleration. Thank you for the advice and help so far and I'll continue to share my findings.

I know the car was tuned by BluPower from the previous owner. Is it possible that the tune would have something to do with it? I've read that the things to check for are the ABS Wheel Speed Sensors and potentially swap them out. Would there be a way to identify which one would need replacing?

I went to Supercheap on the weekend and had them scan the car for codes, and the error codes which came up were. U1900-20 = PCM - CAN Communication Bus Fault -Receive error U2514-20 = PCM - Vehicle speed signal missing or incorrect U2197-60 = BEM - Invalid data for Vehicle speed U2197-2F = HIM - Invalid data for Vehicle speed U2197-28 = ACM - Invalid data for Vehicle speed Has anyone experienced these codes and found a fix to them?

Hi All, I'm experiencing the speedometer cut out while driving. Currently, the car is a weekender and doesn't get used on the weekdays. I started experiencing this issue when I was driving and I pushed the car hard of the line and revs needle will work, but the speed needle will cut out. I have been able to turn the car off and start it back up and drive normal and I do not experience any issues with the speedo needle working again. I have tried to push the car off the line at different intervals in relation to the acceleration force. When driving normal from a stand still its fine, then upping the intensity by 10 percent increments it is okay. I have pushed it gradually to about 50-60% acceleration. I have noticed when I go harder than that or like a heavy foot where I'm asking the car to pick up speed instantly, is when the speedo cuts out. On the cluster, the ABS and ETC light appear for the inital few seconds when the car is picking up speed and then dissappears, not sure if that is a signal to a related problem or problem identifier. Would anyone know what may be causing the speedo to cut out or where to begin with troubleshooting the problem? Thanks guys.