Kroozin
-
Posts
1,990 -
Joined
-
Last visited
-
Days Won
1
Content Type
Profiles
Forums
Gallery
Events
Store
Articles
Media Demo
Everything posted by Kroozin
-
Y u do dis?
-
Ok if I bring some other xr's along? 2 non turbo then 2 turbo. Like I said, maybe. New neighbor wants in
-
Think of the weight reduction
-
Or be a grub n drill some 13mm holes
-
How long of a throw do you have? Also what brand short throw/shifter kit are you using?
-
Good find^^^ Interested to see how that goes. Mines the same (but t56) when cold going into 2nd and 3rd Perfect when up to temp though It's a pita driving around the problem, takes kn'ages to change gears avoiding the knotchy grind feel
-
Helps a f*ckload. You will never see that it's missing the cut out underlay either. Tools required = Stanley knife.
-
Might be in on ^^^ too
-
I most def. will not be bringing my misses lol
-
Mines just gotten an oily film on the intake, pulled the hot side pipe off and found more oil. Can't see that well due to potato pic but can just make out the oil on top of the pipe there..
-
Dif gears maybe too
-
19mm OD copper pipe fits noice'n'toight in the rubber grommet thingy at the back of the rocker cover. Now its 2 x 16mm ID hoses breathing to the catch can. Cost all up 74 bux inc. catch can and 2x hoses with 90deg bend
-
Pressure tested intercooler piping, found that standard blow off valve won't leak under 40psi Cut this thing goes here anyway
-
I've heard of ppl going even cooler like 8's even 9's, any experiences with that?
-
I'm going from Windsor way there n Hm on one tank of flex
-
I made up these for mine The standard setup allows for 10mm of packing. Is your camber kit the one with the bolt or nut or is it done by packers?
-
I forget which plugs to use for eflex 82deg tstat?
-
Did ya take out that pissy little filter out of the fitting that screws into the block of the part you retain when fitting the earls kit? Does your earls fitting have a smaller orifice bit in that union fitting that screws into the turbo? Have ya had a real close look at the compressor side fins for any slight bend or is there much shaft play? Have ya tried pulling out or blocking the BOV?
-
Bjeezus that's out there for 16lb on a Gtx nice work!!
-
Getting something so right with little chance of getting it that good ever again, only to overlook 1 little detail meaning ya need to do it all over again. Doh!!
-
I've found my to have better response than the 3540
-
Rbt *beep* Don't know whether to paint the heat shield black or just leave it.
-
Non-turpo :-/
-
I'll sell my one if they want it 80bux + postage Mines green to red though
-
Maybe try pulling off the rocker cover and retorque all your head bolts. I can't remember which order they are supposed to be retorqued though
