Jump to content

Built tail shaft advice and specs needed.


HI PSI

Recommended Posts

  • Dropping a turd
  • Gold Donating Members
  • Member For: 16y 5m 1d
  • Gender: Male
  • Location: Perth

Chrome moly tube , beefed uni's and HD centre bearing. Final drive in Perth do a great job. Just tell them your power goal and intended use. Its nice to know its fine to step off the clutch while bouncing off the rev limiter.

  • Like 4
Link to comment
Share on other sites

  • Manual mode ________________________ All day, erryday
  • Donating Members
  • Member For: 16y 4m 4d
  • Gender: Male
  • Location: Probably above atmospheric pressure

Think I've killed the new rubber coupling/CV/Uni I had put in a little while ago when the tailshaft maintenance was done .  At first it was all TOIGHT but it soon started clunking again :)

 

My poor car.

  • Like 2
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'