Jump to content

Xxr 530 18X9.75" +20 With 275/35 All Round On Fg Sedan


Super6

Recommended Posts

  • New Member
  • Member For: 9y 6m 6d

Hi all,

Liking the XXR 530 wheels in 18x9.75 +20 . Really want to run 275's all around with about 4 deg camber front , 0 at back if possible.

Clearance on the inside of the wheels will be fine, but concerned about the outside.

Will I need guard work on the front? and wondering how much camber I would need to run front and back (at minimum) to clear the outside?

Any insight would be great, cheers

Keiran

Link to comment
Share on other sites

  • Donating Members
  • Member For: 10y 10m 3d
  • Gender: Male
  • Location: NOR Perth

There's a thread "Fg Offsets And Tyre Questions" which I'm sure the mods may move this back into......

Sounds very aggressive and there's one dude on hear (nelsonian101) who does track days and stuff....and pretty sure he made a thread about his track rims and 275s all round? (or might have been 265s?)

But depending how low you go....I'm not sure how the rears will go? I have 18x9+29 and looks pretty flush with the rears...but still at stock height

Perhaps a pump and roll of guards will sort it out though? (but I think I read that the sedan rear guards cant be rolled too much without causing damage)....

Good luck with it mate! Pics if it actually happens ;)

Link to comment
Share on other sites

  • Donating Members
  • Member For: 11y 7m 2d
  • Gender: Male
  • Location: Sydney

Don't think you'll get away with 0 camber on the rear,

And don't think you'll be able to pull full lock on the front either.

Have a look here...

http://www.fordxr6turbo.com/forum/topic/85736-pics-of-275s-all-round-for-circuit/

Edited by Seaton
Link to comment
Share on other sites

  • New Member
  • Member For: 9y 6m 6d

Yes I did catch that thread. Good knowing somebody has already achieved this, but more looking to find out bare minimums in terms of camber. Ride height will be std. for now

Based on my calculations, the wheel will be 1.1" less diameter than the current 20's (245/35 +35) and 0.1mm difference on the inside, so full lock should be comfortable.

Outside is the issue, will be 30mm wider on the outside than current setup

Edited by Super6
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'