Jump to content

Replaceing Rear Bump Stops Q


jas98

Recommended Posts

  • Member
  • Member For: 11y 8m 28d
  • Gender: Male
  • Location: Maryborough Qld

BA xr6t sedan

my bump stops are non existant as there worn away and fell off

I have got some new ones today that are nolthane,

been reading and read that the factory ones act as part of the spring?? as there so close to teh control arm.

seems that these nolthane ones are smaller......but are for standard replacements.

should they still be ok??

Link to comment
Share on other sites

  • Bronze Donating Members
  • Member For: 10y 11m 29d
  • Gender: Male
  • Location: WA

They could be made for lowered cars. It just means the rear end will sag another 10mm before being bottomed out. It will depend how you like the ride as well. If your rear passengers complain about it being hard then they'll have to walk. Is the car lowered?

Link to comment
Share on other sites

  • Member
  • Member For: 11y 8m 28d
  • Gender: Male
  • Location: Maryborough Qld

they just pull off, theres no bolt. however the replacement ones I got are a bitch to get back on (standard ones are to but not as bad) im still trying to get them on haha

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
  • Create New...
'